Stop Input - V2 CITY2+ Manual Del Usario

Stop Input

This menu permits to select the functions associated to the
command of STOP.
no The input STOP is not available.
ProS The input STOP stops the gate: pressing the command START
the gate continues the motion.
invE The command STOP stops the gate: at the next START the
gate starts moving in the opposite direction.
The setting of parameter STOP determines also in which direction the
gate will move at the next START, if it has stopped because of an
intervention of the safety edges or the obstacle sensor. If you set no, the
START command restarts the motion in the same direction.
NOTE: during the pause, the STOP command will stop the pause time
count, the next START command will always close the gate.
Photocell 1 input
This menu allows enabling the input for type 1 photocells, that is to say,
photocells active both during the opening and closing phase (see
paragraph "Installation").
no Input disabled (ignored by the control unit).
No jumper with the common is required.
AP.Ch Input enabled.
Photocell 2 input
This menu allows enabling the input for type 2 photocells, that is to say,
photocells non active during the opening phase (see paragraph
"Installation").
no Input disabled (ignored by the control unit).
No jumper with the common is required.
CF.Ch Input enabled even at standstill gate too: the opening
movement does not start if photocell is interrupted.
Ch Input enabled for the closing phase only.
Warning: if you select this option, you must disable photocell
test.
Test of the photocells
In order to achieve a safer operation for the user, the unit performs a
photocells operational test, before a normal working cycle.
If no operational faults are found, the gate starts moving.
Otherwise, it will stand still and the flashing light will stay onfor 5 sec.
The whole test cycle lasts less than one second
WARNING: V2 suggests to keep activated the test of the
photocells in order to grant a higher safety of the system.
45