End Of Programming - V2 CITY2+ Manual Del Usario

Encoder Input
The CITY2+ controller allows connection to encoders that provide the
controller with the position of the gate panels
Si The encoder inputs are enabled
no The encoder inputs are disabled
Anti-skid
When an opening or closing operation is interrupted by a command or
for the intervention of the photocell, the set-up time for the opposite
movement would be excessive, so the control unit operates the motors
only for the time necessary to recover the actually covered journey. This
could be not sufficient, particularly in the case of very heavy gates, as
because of the inertia at the inversion moment the gate runs an extra
space in the previous direction that the control unit is not able to take
into account.
If after an inversion the gate does not return exactly to the starting
position, it is possible to set an anti-skid time that is added to the time
calculated by the control unit in order to recover the inertia.
WARNING: When the encoders are installed and enabled, it is not
necessary to enable the anti-skid as the controller is able to detect when
the gate is in the maximum open or closed position.

End of Programming

This menu allows to finish the programming (both default and
personalized) saving the modified data into memory.
no Further corrections to carry out: do not quit the programming.
Si changes complete: when programming is complete and the
data is saved, the display shows the control panel
THE INSERTED DATA HAVE BEEN MEMORIZED: THE CONTROL
UNIT IS READY TO BE USED.
47