Installation Of The Stop Limit Switches; Electrical Connections - V2 VULCAN Instrucciones De Uso E Instalación

INSTALLATION OF THE STOP LIMIT
SWITCHES
1. Place the gate in the maximum closed position, and then
attach the limit switch screw as shown in the figure.

ELECTRICAL CONNECTIONS

VULCAN-230V / VULCAN-120V
YELLOW - GREEN GND
BLUE COMMON
BLACK OPENING / CLOSING
BROWN CLOSING / OPENING
WARNING: Always connect the earth cable to the
mains power earth system. Use the special fastom shown
in the figure, and a cable with a minimum cross sectional
area of 2.5 mm 2
VULCAN-24V
BLUE OPENING / CLOSING
BROWN CLOSING / OPENING
Hereafter the directions to follow to connect the cables of the
encoder to the control unit:
• Red cable - power supply of accessories [+ 24VDC]
• Black cable - common inputs [COM (-)]
• Blue cable - signal of the encoder
• White cable - signal of the encoder
• Shielding braid sheath
Check that the ground of the power supply of the accessories is
connected to the common accessories
WARNING: extensions of the cables must be made
only with a 4x0,22 shielded cable with polyethylene
sheath
- common input [COM (-)]
2. Place the gate in the maximum open position, and then
attach the limit switch nut as shown in the figure, and
tighten the screw.
11