V2 CITY2+ Manual Del Usario página 41

Silent Locking Mode
This menu allows you to select the silent operation mode for the electric
lock.
Si Silent Mode (100 Hz)
no Standard Mode (50 Hz)
CAUTION: In silent mode, the voltage supplied to the lock has a
higher frequency in order to make the locking less noisy.
In some cases, there may be problems when unlocking. If problems
should occur, select the Standard mode.
Lock advance time
While the electric lock is energized, the gate will stay standstill for t.ASE
time, to make its release easier.
In case t.ASE is lower than t.SEr, the lock energizing will go on while
the doors will start moving.
WARNING: in case the gate has no electric lock, set the value 0.
Backlash time
It could be useful to give a closing command to motors, to help the
electric lock release.
The control unit controls the motors in reduced power in closing
direction for the setup time.
The backlash precedes the electric lock release. It is possible to reverse the
order by setting a lock advance time higher then the backlash one.
WARNING: in case the gate has no electric lock, set the value 0.
Pre-blinking time
Before any gate movement, blinker will be activated for t.PrE time, to
warn about the incoming motion.
Motor 1 power
This menu allows adjusting the motor 1 power.
The displayed value is the percentage of max. motor power.
39