Plug In Receiver; External Aerial; Adi Interface; Electric Connections Table - V2 CITY2+ Manual Del Usario

EXTERNAL AERIAL

We suggest to use the external aerial (model: ANSGP433) in
order to guarantee the maximal range.
Connect the antenna hot pole to terminal L1 (ANT) of the
control unit and the braiding to terminal L2 (ANT-).

PLUG IN RECEIVER

CITY2+ control unit is suitable for plugging in a Personal Pass
MR1 receiver having a high-sensitivity super-heterodyne
architecture.
WARNING: it is necessary to turn off the control unit
power before doing the operations mentioned here below. Pay
attention to the way you connect the removable modules.
MR1 module receiver is provided with 4 channels and each of
them is suitable for a command of CITY2+ control unit:
CHANNEL 1 START
CHANNEL 2 PEDESTRIAN START
CHANNEL 3 STOP
CHANNEL 4 COURTESY LIGHT
WARNING: Before programming 4 channels and function
logics read carefully the instructions of MR1.
INTERFACE
The ADI (Additional Devices Interface) interface of the control
unit CITY2+ allows the connection to V2 optional modules.
Refer to V2 catalogue or to the technical sheets to see which
optional modules with ADI interface are available for this control
unit.
WARNING: Please read the instructions of each single
module to install the optional modules.

ELECTRIC CONNECTIONS TABLE

L1 Antenna
L2 Antenna shield
Opening control for the connection of control
L3
devices with N.O. contact
Opening controls for pedestrian access for the
L4
connection of control devices with N.O. contact
L5 Stop command. N.C. contact
L6 Common (-)
L7 Photocells type 1. N.C. contact
L8 Photocells type 2. N.C. contact
L9 Safety ribbons type 1 (fixed). N.C. contact
L10 Safety ribbons type 2 (mobile). N.C. contact
L11 Common (-)
K1 Open limit switch motor 1
K2 Close limit switch motor 1
K3 Open limit switch motor 2
K4 Close limit switch motor 2
K5 Common (-)
Power output +24Vdc for photocells and other
K6
accessories
K7 Common for accessories power supply
Photocell/optical edge TX power supply for
K8
functional test
K9 - K10 LOCK 12V
Z1 - Z2 24V courtesy light or flashing light
Z3 Motor 1 (+)
Z4 Motor 1 (-)
Z5 Motor 2 (+)
Z6 Motor 2 (-)
B1 - B2 230VAC courtesy light or flashing light
Interface
It shows that there is an overload on accessories
OVERLOAD
power supply
BAT+ + Pole of optional battery pack (code 161212)
BAT- - Pole of optional battery pack (code 161212)
L Power phase 230 VAC / 120VAC
N Neutral 230 VAC / 120VAC
MAINS It shows that the control unit is power supplied
32
Encoder motor 2
Encoder motor 1