Using The Battery Pack - Pulsar ACCOLADE 2 LRF Manual Del Usuario

5
FUNCTIONS OF CONTROL BUTTONS
BUTTON CURRENT FIRST SHORT
OPERATING MODE PRESS
Device is off Power device on Calibrate the sensor
ON/OFF
(1)
Display OFF Turn display on Calibrate the sensor
mode
Device is on
Regular
UP (2)
Rangefinder
Menu
Navigation upwards/rightwards navigation
MENU (3)
Regular Enter quick menu Switch between
Menu
navigation
DOWN
Regular
Control incremental digital zoom
(5)
Menu
Navigation downwards/leftwards
navigation
REC (4) Video Start video
recording
Photo Take a photograph
OTHER SHORT LONG PRESS
PRESSES
Turn display off/
Power device off
Calibrate the sensor
Switch between
Activate rangefinder
colour palettes
Start/stop
Measure distance
SCAN mode
Enter main menu
quick menu options
Confirm selection
Operating Modes
Pause / resume Stop video recording /
video recording Switch to photo mode
Switch to video mode
6

USING THE BATTERY PACK

Accolade 2 LRF thermal imaging binoculars are supplied with a
rechargeable Li-Ion Battery Pack IPS7 which allows operation for up to
9 hours. Please remember to charge the Battery Pack before first use.
Charging:
Lift the lever (C) of the charging base.
Remove the protective cover from the Battery Pack.
Install the Battery Pack into the charging base as shown in Pic.2;
click the lever (C).
Upon installation, a green LED indicator (D) on the charging base
will start to glow and begin flashing:
- once if the battery charge ranges from 0% to 50%;
- twice if the battery charge ranges from 51% to 75%;
- three times if the battery charge ranges from 76% to 100%;
If the indicator lights green continuously, the battery is fully charged.
----
You can remove the battery from the charger by lifting the lever (10).
If the indicator of the charger lights red continuously upon battery
installation, probably the battery's charge level is lower than
acceptable (the battery has been long in deep discharge).
----
Keep the battery in the charger for a long time (up to several hours),
remove and re-insert it. If the indicator starts blinking green, the
battery is good; if it keeps lighting red it's defective.
Do not use the battery!
----
Connect the Micro-USB plug of the USB cable to the port (E) of the
charger.
Connect the Micro-USB plug to the charger.
Insert the plug of the charger to the 220 V socket.
3