External Power Supply - Pulsar ACCOLADE 2 LRF Manual Del Usuario

C
D
Charging
base
Battery Pack
Installing the Battery Pack:
Lift the lever (10).
Install the battery (9) all the
way into the dedicated slot on
the device housing so that
element F appears from below
(Pic.3) .
Fix the battery by clicking the
lever.
Safety measures:
Only use the charger supplied with your binoculars.
When keeping the battery for a long period, the battery should
not be fully charged or fully discharged.
Do not charge the battery immediately after bringing the
battery from cold environment to a warm one. Wait for 30 - 40
minutes for the battery to get warm.
Charge the Battery Pack at a temperature from 0 °C to +45 °C.
Otherwise batter's life will decrease significantly.
Do not leave a battery unattended while charging.
Never use a modified or damaged charger.
Do not leave the Battery Pack with a charger connected to the
mains longer than 24 hours after full charge.
E
Charger
220V socket
Pic. 2
9 10
Pic. 3
Do not expose the battery pack to high temperature or to a naked
flame.
Do not submerge the battery in water.
Do not connect external device with a current consumption that
exceeds permitted levels.
The Battery Pack is short circuit protected. However, any situation
that may cause short-circuiting should be avoided.
Do not dismantle or deform the Battery Pack.
Do not drop or hit the battery.
When using the battery at negative temperatures, battery's capacity
decreases, this is normal and is not a defect.
Do not use the battery at the temperatures above those shown in
the table – this may decrease battery's life.
Keep the battery out of the reach of children.
7

EXTERNAL POWER SUPPLY

The device can be powered with an external power supply such as
Power Bank (5 V).
Connect the external power supply to the USB port (15) of the device
(Pic. 1).
The device switches to operation from external power supply, and the
IPS7 Battery Pack will begin slowly charging.
The display will show the battery icon
percentage.
If the device operates on external power supply but the IPS7 battery is
not connected, icon
When the external power supply is disconnected, the device switches
to the internal battery pack without powering off.
Attention! Charging IPS7/IPS14 batteries at air temperatures below
0 °C can result in reduced battery life. When using external power,
connect Power Bank to the switched-on riflescope, which have
worked for several minutes.
8
OPERATION
WARNING!
Do not point the objective lens of the device at intensive sources
of light such device emitting laser radiation or the sun. This may
render the electronic components inoperative. The warranty does
not cover damage caused by improper operation.
with charge level as a
is shown.
4