Pulsar ACCOLADE 2 LRF Manual Del Usuario página 13

Remote
Remote control activation (bought separately)
Control
Before operating the remote control (RC),
remember to activate it as follows:
Press and hold down the М (3) button to enter the
=
main menu.
Select option «
=
(2)/DOWN (5) buttons. Press briefly М to confirm.
Press briefly М to confirm.
=
Display shows message «Wait» and countdown
=
starts (30 sec), within which hold down for two
seconds any RC button.
If activation is successful, the message
=
«Connection complete» appears
If error occurs the message «Connection failed»
=
appears
The RC is activated and ready for use.
=
To unlink the RC, press the М button, wait for the
=
countdown to expire without pressing any RC
button for 30 sec.
All remote controls previously linked to your
=
device are now unlinked.
Now you can activate your RC again or activate
=
another RC.
Defective
Defective pixel repair
pixel repair
When operating a thermal imager, defective (dead)
pixels (bright or dark dots with constant brightness)
may become visible on the sensor.
Defective pixels on the sensor may proportionally
increase in size when digital zoom is activated.
Accolade 2 LRF
to repair defective pixels on the detector using a
software-based method or to abort deletion.
Press and hold down the М (3) button to enter the
=
G
main menu.
Select option «
H
=
UP (2)/DOWN (5) buttons. Press briefly М to
x=95
I
confirm.
y=99
Press briefly М to confirm.
=
A marker (H)
=
display.
Remote Control » with the UP
.
. Repeat the procedure.
thermal binoculars allow the user
Defective pixel repair » with the
appears on the left side of the
On the right side of the display appears
=
«magnifying glass» (G) – a magnified image in a
frame with a fixed cross
detection of a defective pixel and to match the
pixel with the marker, horizontal and vertical
arrows for X and Y axes (I) showing marker's
movement.
With a short press of the UP/ DOWN buttons
=
move the marker to align it with a defective pixel.
Switch the direction of the marker from horizontal
=
to vertical and vice versa with a short press of the
M button.
Align the defective pixel with the fixed cross in the
=
frame – the pixel should disappear.
Delete the defective pixel with a brief press of the
=
REC (4) button.
A brief message «OK» appears in the frame in
=
case of success.
Then you can delete another defective pixel by
=
moving the marker along the display.
Exit «Defective pixel repair» with a long press of
=
the M button.
Attention! The display of a thermal imager may have 1-2
pixels represented as bright white or color (blue, red) dots
which cannot be deleted and are not a defect.
Return to default defective pixel pattern
This option allows you to cancel deletion of the
defective pixels and return them to the original
state.
Enter the submenu with a brief press of the M
=
button.
Select icon
=
Select «Yes» if you wish to return to default
=
defective pixel pattern, or «No» if you do not.
Confirm selection with a short press of the M
=
button.
This option allows the user to view the following
information about the device:
Device
Full name
information
=
SKU number
=
serial number
=
Select menu option Device information with a brief press of the M button
to review information.
, designed for easier
and press М.
software version
=
hardware version
=
service information
=
10