Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Laser marking on the head of the tracpode: refer to
figure 7.b.
GB
12. Periodic inspection and repair
An annual periodic inspection is mandatory, but
depending on the frequency of use, environmental
conditions and regulations of the company or the
country of use, periodic inspections may be more
frequent.
Periodic inspections shall be carried out by an approved
and competent technician, and in accordance with the
manufacturer's inspection procedures reproduced in
the "Verification procedures for TRACTEL
Verification of the legibility of the markings on the
product is an integral part of the periodic inspection.
On completion of the periodic inspection, the return to
service must be indicated in writing by the authorised
and competent technician who carried out the
inspection. This return to service must be recorded
on the inspection record in the middle of this manual.
This inspection record should be retained throughout
the product's service life, up until it is deemed unfit for
service.
After arresting a fall, this product must undergo a
periodic inspection as described in this manual. The
product's textile components must be replaced, even
though they may not show any visible deterioration.
TRACTEL
textile PPE such as harnesses, lanyards,
®
ropes and shock absorbers, TRACTEL
PPE such as stopcable™ and stopfor™ fall arresters,
blocfor™ self-retracting fall arresters and TRACTEL
lifelines can be used on condition that, from their date
of manufacture onwards, they are:
– used
normally,
recommendations given in this manual.
– inspected periodically at least once a year by an
approved and competent technician. On completion
of this periodic inspection, it must be certified in
writing that the PPE is fit to be returned to service.
– stored and transported in strict compliance with the
conditions indicated in this manual.
14
®
13. Service life
®
in
accordance
When disposing of the product, all components
must be recycled by firstly sorting them into metallic
and synthetic materials. These materials must be
recycled by specialist organisations. During disposal,
dismantling in order to separate the components should
be undertaken by a suitably trained person.
PPE" file.
mechanical
®
with
the
14. Disposal
Tabla de contenido
