Ryobi RLT26CDS Manual De Utilización página 20

EN
FR DE ES
Line will not advance.
Grass wraps round
shaft
h o u s i n g a n d b u m p
head.
Bump knob hard to turn.
Oil drips from silencer.
NOTE: If your unit exhibits speci¿ c performance problem(s) where the Troubleshooting section recommends a clockwise
screw adjustment on the carburetor and no adjustments have been made since original purchase, the unit should
be taken to an authorised service centre for repair. In most cases, the needed adjustment is a simple task for the
trained service representative.
IT PT NL SV DA
English(Original instructions)
1. Line welded to itself.
2. Not enough line on spool.
3. Line worn too short.
4. Line tangled on spool.
5. Engine speed too slow.
1. Cutting tall grass at ground
level.
2. Operating trimmer at part
throttle.
S c r e w s t h r e a d s d i r t y o r
damaged.
1. Operating trimmer at part
throttle.
2. Check oil/fuel mixture.
3. Air filter dirty.
NO FI HU CS RU
1. Lubricate with silicone spray.
2. Install more line. Refer to "Line Replacement" earlier
in this manual.
3. Pull lines while alternately pressing down on and
releasing bump head.
4. Remove line from spool and rewind. Refer to "Line
Replacement" earlier in this manual.
5. Advance line at full throttle.
1. Cut tall grass from the top down.
2. Operate trimmer at full throttle.
Clean threads and lubricate with grease - if no
improvement, replace bump knob.
1. Operate trimmer at full throttle.
2. Use fresh fuel and the correct synthetic 2-stroke oil
mix.
3. Clean per instruction in Maintenance Section.
17
RO PL SL HR ET LT LV SK BG