EN
FR
DE
ES
SPOOL REPLACEMENT (Fig. 11)
LINE REPLACEMENT (Fig. 11)
Ensure the unit is in the off position
Remove the spark plug lead, to prevent accidental
starting.
Use 2.4mm diameter monofilament string.
Cut one piece of string approximately 6.0m in length
Rotate knob on string head until line on knob aligns
with arrows on top of string head.
Insert one end of string into eyelet located on the
side of the string head and push until string comes
out through eyelet on the other side. Continue to
push string through the string head until the middle
section of the string is inside the string head and
string outside the string head is evenly divided on
each side.
Rotate the knob on the string head counterclockwise
to wind the string
Wind the string until approximately 20cm remains
protruding from the string head.
CLEANING THE EXHAUST PORT AND
SILENCER
Depending on the type of fuel used, the type and amount
of oil used, and/or your operating conditions, the exhaust
port and silencer may become blocked with carbon
deposits. If you notice a power loss with your petrol
powered tool, a qualified service technician will need to
remove these deposits to restore performance.
SPARK ARRESTOR
The spark arrestor must be cleaned or replaced every
25 hours or yearly to ensure proper performance of
your product. Spark arrestors may be in different
locations depending on the model purchased. Please
contact your nearest service dealer for the location of the
spark arrestor for your model.
CLEANING THE AIR FILTER SCREEN (Fig. 8)
For proper performance and long life, keep air filter
screen clean.
Remove the air filter cover by pushing down on the latch
with your thumb while gently pulling on the cover.
Brush the air filter screen lightly to clean.
Replace the air filter cover by inserting the tabs on the
bottom of the cover into the slots on the air filter base;
push the cover up until it latches securely in place.
IT
PT
NL
SV
DA
English(Original instructions)
NO
FI
HU CS RU
FUEL CAP
WARNING
A leaking fuel cap is a fire hazard and must be
replaced immediately.
The fuel cap contains a non-service able filter and a
check valve. A clogged fuel filter will cause poor engine
performance. If performance improves when the fuel cap
is loosened, check valve may be faulty or filter clogged.
Replace fuel cap if required.
SPARK PLUG REPLACEMENT (Fig. 9)
This engine uses a Champion RCJ-6Y or NGK BPMR7A
spark plug with .05 in. electrode gap. Use an exact
replacement and replace annually.
IDLE SPEED ADJUSTMENT (Fig. 10)
If the cutting attachment turns at idle, the idle speed
screw needs adjusting on the engine. Turn the idle speed
screw counterclockwise to reduce the idle RPM and
stop the cutting attachment movement. If the cutting
attachment still moves at idle speed, contact a service
dealer for adjustment and discontinue use until the repair
is made.
STORING THE PRODUCT
Clean all foreign material from the product. Store
idle unit indoors in a dry, well-ventilated area that is
in- accessible to children. Keep away from corrosive
agents such as garden chemicals.
Abide by all ISO and local regulations for the safe
storage and handling of petrol.
When storing 1 month or longer:
Drain all fuel from tank into a container approved for
petrol. Run engine until it stops.
15
15
RO PL
SL
HR ET
LT
LV
SK BG