Connecting Power - Siemens SITRANS FUS1010 Guia De Inicio Rapido

Tabla de contenido

Idiomas disponibles

Quick Start Guide

WARNING: Turn off main power before installing AC connections to the Flow Display Computer. Contact with exposed wiring

may lead to fire, electric shock, or serious personal injury.

Open the Flow Display Computer top cover by releasing the cover latch.

Unscrew the two power supply access cover fasteners and remove access cover.

Locate power supply connector J10. Using a flat blade screwdriver, remove plug P10 from connector J10. Set aside.

NOTE: Agency approved units will be fused with F1 and non-agency approved units will have an On/Off breaker switch.

Power Supply Label

Siemens

Power Supply

Access Cover

Pull the desired length of input power wires through a cable gland and into Flow Display Computer case before wiring

connector.

Wire input power connector P10 for AC or DC power depending on power supply provided. Insert wires into wire entry

holes and secure by tightening wire clamp screws (see figure above). NOTE: Power Supply connector wires should be

stripped AWG 12 -18 stranded wire or solid conductors.

Plug input power plug P10 into connector J10 and secure using two captive connector mounting screws.

Replace access cover. Make sure the Keypad Enable switch is in the "Enable" position (see below).

Caution: Improper connections will damage power supply. Turn power switch to ON (if so equipped). Connect the

power cables to the appropriate power source (100-250 VAC @ 50/60 Hz or 9-36 VDC). Close top cover.

Within 10 seconds of power-up the Flow Display Computer main display will become active and a typical Siemens

graphic will appear. The screen also identifies the software version of the unit as shown below.

Press the <MENU> key and the Main Menu will appear. (Note: Language selection not on Version 3 op system.)

Siemens

2 Channel [1]

Select Meter Type

Meter Type

Meter Facilities

Language