STACK-ON SS-16-MB-B Instrucciones

SS-16-MB-B
WARNING
A child or adult can tip the safe and
be killed or seriously injured.
Failure to secure the safe as shown in
these instructions can result in death
or serious injury to children and adults.
Children should not play with or
around the safe at any time.
Serial #
Hardware Included:
(4) M10x70 Lag screws
(4) washers
(4) plastic anchors
(6) #8 X 1/2 Screws
Tools required:
drill
7/16" drill bit
3/8" drill bit
17mm socket wrench
Phillips screwdriver.
®
Instructions
Tip Over Hazard
IMPORTANT
• Record the serial number from the tag on the
back of the safe or from the tag on the front
bottom corner of the safe.
• Keep keys in a secure place away from
children.
• Do not store the back up key, or this document
in the safe.
• Do not move this safe using its handle. The
handle should only be used for opening and
closing the door of the safe.
• Warning: Keep your safe closed and locked at
all times when not in use. Children could
accidentally be locked inside the safe.
BATTERY INSTALLATION
You must first install the ba eries which are
located in the ont protective Styrofoam.
is safe uses 4 - AAA ba eries. Under normal
use, ba eries will last about 1 year.
NOTE: Do not mix old and new ba eries.
Do not mix alkaline, standard or rechargeable
ba eries.
NOTE: When changing or installing the
ba eries, do not pull on the wires. Doing this
could cause the power supply to become
disconnected from the lock.
NOTE: If the ba eries are low, the yellow light
will flash when you press the scanner.
To replace the ba eries, remove the lock faceplate
by pressing the tab and turning the cover as shown
in the illustration below.
TAB
1
14
40677-2203