Entering Your Security Code - STACK-ON SHD-SU-BG-E Manual De Instrucciones

ENTERING YOUR SECURITY CODE

To enter your own security code follow
the steps listed below:
1. After opening the electronic safe with the
preset factory code of 1 - 5 - 9 - # locate the
small red button on the inside of the door near
the hinge.
2. Press the red button and then release it, you
will hear a beep. The yellow light on the
faceplate will be activated and will stay on for a
period of time that will allow you to enter your
code. You can only enter your code while the
yellow light is on.
With the door open and the yellow light on,
enter your own personal security code, which
can be 3 - 8 digits long, and confirm your new
code by pressing the "
electronic touch pad. Before you close the
door, try the new security code to make sure
the lock releases the handle so you can turn it
and retract the live action bolts.
DO NOT SHUT THE DOOR UNTIL YOU HAVE
CONFIRMED YOUR NEW SECURITY CODE HAS
BEEN ENTERED AND WORKS CORRECTLY.
" symbol on the
If the code fails, go through steps 1 and 2 again.
If the code works successfully, record your
combination number on the front of this form or
store your combination on our secure website at
stackon.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from
children, not inside the safe. Then you should
close and lock the safe.
When you open the safe in the future enter the
security code you have set followed by the " # "
symbol.
If the incorrect security code is entered 3 times
you will have an automatic lockout for 20
seconds before you can try your code again.
If the incorrect code is entered 3 additional
times you will have a 5 minute lockout before
you can try your code again.
3
16
40718-1704