Battery Installation; Selecting A Location - STACK-ON TDS-42-SG-E-S Manual De Instrucciones

BATTERY INSTALLATION

NOTE: When changing the battery, always hold
the battery connecting cap while disconnecting
or attaching the battery. Do not pull on the
wires. Doing this could cause the power supply
to become disconnected from the lock.
This safe uses one 9V alkaline battery. Under
normal use, batteries will last about 1 year.
When the battery is low and you press a button
on the keypad, a red light will come on warning
you that the battery is low.
To test the battery, enter your security code.
If the battery is low the red light will come
on momentarily.
To replace the battery, remove the lock face by
pressing the tab and turning the lock face as
shown in the illustration. Replace the old
battery and screw the lock face back in place.
TAB

SELECTING A LOCATION

The safe must be mounted to the floor. For
optimal safety and security, the safe should
be installed adjacent to a side wall with
minimal space on either side of the safe, in an
isolated, dry and secure area.
The safe should be flat against the wall and
floor. Remove the baseboard if necessary.
CHILDREN SHOULD NOT PLAY WITH OR
AROUND THE SAFE AT ANY TIME.
4
14
40828-1806