Description And Function; Description Of The Product - salmson LRE Serie Instalacion Y Puesta En Servicio

English
6

Description and function

6.1

Description of the product

Functional assemblies
Electronic module
1 2 3
8
Fig. 9: Electronic module
66
• IF-Module LON for connection to the LONWORKS network
• IF-Module BACnet
• IF-Module Modbus
• CAN IF-Module
4 5
• Energy saving at the same time as reduced operating costs
• Reduced number of differential pressure valves required
• Reduction of flow noise
• Adaptation of the pump to changing operating requirements
7 6
For a detailed list, consult the catalogue and spare parts documenta-
tion.
NOTE:
IF-Module may only be plugged in when the pump is de-energised
(voltage-free).
The pumps described here are single-stage low-pressure centrifugal
pumps with a compact construction and a coupled drive. The pumps
can be installed both directly as a pipe installation pump in a suffi-
ciently anchored pipe or placed on a foundation base.
The pump housing of the LRE and the JRE is configured in an in-line
design, i.e. the flanges on the suction and pressure sides are located
in the same axis. All pump housings are provided with pump support
feet. Installation on a foundation base is recommended.
NOTE:
Blind flanges, which allow the motor impeller unit to be replaced even
in double pump housing, are available for all pump types/frame sizes in
the JRE series (see chapter 5.4 "Accessories" on page 65). A drive can
therefore remain in operation while replacing the motor impeller unit.
The electronic module controls the speed of the pump within the
control range that can be adjusted by the setpoint.
The hydraulic output is controlled by differential pressure and the set
control mode.
In all control modes, however, the pump adapts itself continuously to
the changing power requirements of the system, which is the case
especially when thermostatic valves or mixers are used.
The basic advantages of the electronic control are:
Legend (Fig. 9):
1 Attachment point, cover
2 The white button
3 Infrared window
4 Control terminals
5 Display
6 DIP switch
7 Power terminals (mains terminals)
8 Interface for IF-Module
Salmson 11/2017