Cebora PLASMA PROF 180 HQC Manual De Instrucciones página 114

Select the type of material by pressing the button under Material: relevant permissible gas combinations are then
displayed. After selecting the gas by pressing the button under Gas, select the thickness and cutting current. The
system automatically displays the set of consumables suitable for these settings and related to the type of torch in
use (in this example, torch CP455G).
The second setting to be carried out, in sequence, is the selection shown in Fig. 4.11. (CUT screen).
The current processing type is set by the CNC runtime: if this is in cutting mode, then CUT appears in red instead
of white. Given that the system is automatically set up with the flows and current indicated in the cutting charts (see
instruction manual code 3.301.097), these parameters can be adjusted within certain ranges.
Fig. 4.11
Flows can be adjusted for each channel by touching the numeric area of the channel and thus activating the gas flow.
Then turn the corresponding pressure regulator knob until the cursor is in the central area. Press the numeric area
again to cut off the gas flow.
The numeric value of each channel indicates the actual pressure of the flow leaving the torch.
When the set pressure value is outside the recommended range, the bar below the numeric value turns red; otherwise,
the bar turns green.
The cutting current can be adjusted using the "+" and "–" buttons located next to the relevant numeric value. The
current is adjusted in 1 A steps within the predefined ranges (see cutting charts).
After setting the values described above, press the RUN button to activate the power source for cutting. The RUN key
therefore changes from white to yellow and finally to green (see Fig. 4.12 and Fig. 4.13).
Fig. 4.12
114/128