Honeywell HW3000 Manual Del Propietário página 15

Step 3: Install Handle Assembly
To install handle assembly, you will need:
‰ Handle bars with brackets (2)
‰ Rubber handle grips (2)
‰ M8 X 40 mm long full-thread hex flange bolts (4)
‰ M10 serrated flange nuts (4)
‰ Socket wrench with 8 mm socket
‰ 10 mm open end wrench*
* Not included
Slide rubber handle grip onto each handle bar and tap
1.
on hard surface until fully seated.
FIGURE 11: Attach Grips to Handle
Hold handle pivot bracket over pre-drilled holes on
2.
frame as shown in Figure 12.
FIGURE 12: Handle Bracket to Frame
HW3000/HW3000L Portable Electrical Generator Owner's Manual
3.
4.
*
• Keep hands and fingers clear from hinges when
• Handles should only be used to roll the generator to a
•
•
Attach bracket to frame using 40 mm long full-thread
hex flange bolts and serrated flange nuts and tighten.
Confirm the handle bar is securely fastened to the
bracket as it may have loosened during shipping.
FIGURE 13: Tighten Handle Bar Bolt
CAUTION
Hands and fingers can be pinched from collapsible
handles.
collapsing generator handles.
new location. If lifting the generator (i.e. into a vehicle),
never use the handles to support the complete weight
of the generator.
To collapse handles, push in the locking pin and
adjust the handle downward until it rests vertically
against the generator frame.
To return handles to horizontal position, push in
the locking pin and pull up on handle until the locking
pins lock in place.
www.honeywellgenerators.com
Assembly
9