Honeywell HW3000 Manual Del Propietário página 14

Assembly
Step 2: Install Wheel Axle and Wheels
To install wheel assembly, you will need:
‰ Wheel axle (1)
‰ M10 x 16 mm long full-thread hex flange bolts (4)
‰ M13 serrated flange nuts (4)
‰ Axle bracket *
(1)
‰ Wheels (2)
‰ M17 x 30 mm OD x 2.5 mm washers (2)
‰ Snap pins (2)
‰ 13 mm open end wrench
‰ Socket wrench with 10 mm socket
‰ Pliers †
* Two brackets are needed to install wheel axle. One bracket
comes already attached to wheel axle; other bracket is included
in accessory kit box.
† Not included.
Install wheel axle brackets to frame using 16 mm long
1.
full-thread hex flange bolts and serrated flange nuts.
Install pre-attached bracket to frame first.
1A.
NOTE:
Axle brackets are offset (one side longer than the other),
place with the short side up during installation.
1B. Install other bracket (included in hardware bag) to
frame.
FIGURE 8: Wheel Axle Attached to Generator
8 www.honeywellgenerators.com
†
†
On each end of axle:
2. Slide and push wheel onto axle until it fits snug
against washer.
FIGURE 9: Slide Wheel onto Wheel Axle
3. Slide washer onto axle.
Slide snap pin into pre-drilled hole using pliers until
4.
fully seated.
FIGURE 10: Snap Pin Installation
Return generator to upright position (so that wheels
5.
and leg supports are touching the ground).
HW3000/HW3000L Portable Electrical Generator Owner's Manual