Initial Operation; Fitting/Changing The Saw Blade; Fitting The Guide Fence; Connecting The Sawdust Extraction Appliance - Parkside PSTK 800 B2 Manual De Instrucciones Original

Initial operation

Fitting/changing the saw blade

Always remove the plug from the power socket
before working on the appliance.
♦ Remove the pivoting guard
♦ Turn the quick-release chuck
this position.
♦ Press the required saw blade into the quick-
release chuck as far as the limit stop.
♦ Release the quick-release chuck
return to its initial position. The saw blade is
now locked.
■ WARNING! The saw blade teeth must point
forwards at this point (see foldout page)!
♦ Replace the pivoting guard
device.

Fitting the guide fence

The guide fence can be fitted on the left or
right of the appliance.
♦ Undo both of the clamping screws on the
insertion openings
♦ Push the guide fence
openings .
NOTE
► The two respective marking arrows indicate
the cutting width.
♦ Retighten the two locking screws.
Connecting the sawdust extraction
appliance
♦ Push the reducer
until it is secured.
♦ Attach an approved dust and sawdust extractor
to the reducer or extraction connector
directly.
│ GB │ MT
■ 36
.
and hold it in
– it must
back onto the
.
into the insertion
into the extraction connector

Fitting the splinter guard

The splinter guard can prevent the tearing up of
the surface when sawing wood. The splinter guard
can only be used with certain sawblade types
and only at a cutting angle of 0°.
♦ Press the splinter guard
from below (arrow facing upwards).

Operation

Setting the cutting angle

♦ Push the clamping lever
baseplate to the front.
♦ Adjust the cutting angle to 0°/ 22,5°/ 45° with
the aid of the markings on the baseplate
Push the baseplate
locking pin engages in the toothing
♦ Push the clamping lever
NOTE
► With a cutting angle of 22,5°/ 45°, the piv-
oting guard must be removed beforehand!
If the baseplate
clamping lever
nector , then tighten the clamping screw
with hex key.

Setting the stroke rate

♦ Use the stroke rate preselection adjusting
wheel to set the required stroke rate.
into the sliding shoe
forward and pull the
to the rear so that the
.
backwards.
cannot be locked well by
, remove the extraction con-
PSTK 800 B2
.