Tightening The Bolted Connection In "Bolting" Operating Mode - Hilti SI­-AT-­A22 Manual De Instrucciones Original

Result 1 / 4
• The symbol indicating "Bolting completed successfully" is displayed.
• The indicator LEDs light green.
• The confirmation tone is emitted.
The bolted connection has been tightened correctly. You may proceed
with the next bolted connection of the same type.
Result 2 / 4
• The symbol indicating "Bolting completed successfully" is displayed.
• The indicator LEDs blink green.
• The confirmation tone is emitted.
A bolted connection already tightened and subsequently released has
now been retightened. The operation was carried out in accordance
with specially defined retightening parameters and has been completed
successfully.
Result 3 / 4
• The symbol indicating "Battery voltage too low" is displayed.
• The indicator LEDs light red.
The power remaining in the battery is inadequate for the next bolted
connection.
▶ Press the OK button to confirm the message.
▶ Fit a charged battery.
Result 4 / 4
• The symbol indicating "Bolting not completed correctly" is displayed.
• The indicator LEDs light red.
• The warning tone is emitted.
▶ Use a suitable torque wrench to tighten the bolted connection.
▶ Once you have tightened the bolted connection, confirm this by
pressing the OK button.

5.9 Tightening the bolted connection in "Bolting" operating mode

1. Set the tool to the "Bolting" operating mode.
2. Determine the tightening setting for the bolted connection to be made
→ page 11 and set this accordingly.
3. Set the forward/reverse switch to the "Forward" position.
Printed: 10.02.2017 | Doc-Nr: PUB / 5331558 / 000 / 00
English 15