Gas and Electric Supply Clearances
For nearly-flush installation to
For nearly-flush installation to
For nearly-flush installation to
the back wall, the gas supply
the back wall, the gas supply
the back wall, the gas supply
line and electrical cord should
line and electrical cord should
line and electrical cord should
not go above this line.
not go above this line.
not go above this line.
Model
36'' (913 mm)
48'' (1219 mm)
NOTICE:
— If not already present, install gas shut-off valve in an
easily accessible location.
— Make sure all users know where and how to shut off
the gas supply to the range.
— Any opening in the wall behind the appliance and any
opening in the floor under the appliance must be
sealed.
The range must be connected only to the type of gas
for which it is certified. If the range is to be connected to
propane gas, ensure that the propane gas supply tank is
equipped with its own high pressure regulator in addition to
the pressure regulator supplied with the range (see "STEP
6: Gas Requirements and Hookup" on page 16).
NOTE: The range is designed for flush installation to the
back wall. For a successful installation, it may be
necessary to reposition the gas-supply line and electrical
cord as the range is pushed back to its final position.
SUGGESTION: Carefully pull on a rope or twine looped
around the gas or electrical supply line as the range is
pushed back into its final installed position.
Installation Instructions
36" or 48" (914 or 1219 mm)
36" or 48" (914 or 1219 mm)
36" or 48" (914 or 1219 mm)
10"
10"
10"
(254 mm)
(254 mm)
(254 mm)
A A
B B
A
9 '' (232 mm)
7 '' (187 mm)
23 '' (587 mm)
7'' (178 mm)
Gas Zone
Electric Zone
Electric Zone
Electric Zone
3"
3"
3"
(76 mm)
(76 mm)
(76 mm)
C C
B
7 '' (187 mm)
7'' (178 mm)
Electrical Supply
IMPORTANT:
The cord supplied with the gas ranges, having an electric
griddle, requires a NEMA 5-20 receptacle, shown here.
Local codes may require a different wiring method.
WARNING
This appliance is equipped with a three-prong grounding
plug for protection against shock hazard and should be
plugged directly into a properly grounded receptacle. DO
NOT cut or remove the grounding prong from this plug.
DO NOT ALTER THIS PLUG.
2" (51 mm) max.
2" (51 mm) max.
2" (51 mm) max.
protrusion from wall
protrusion from wall
protrusion from wall
for gas or electrical
for gas or electrical
for gas or electrical
supply.
supply.
supply.
D D
C
9 '' (232 mm)
7 '' (200 mm)
Figure 5: Gas & Electrical Supply Locations
D
English 11