Safety Information; Regular Checks - SKYLOTEC MILAN Manual Del Usuario

SKYLOTEC - High Protection. Best Performance.

5. SAFETY INFORMATION

The application of the device is only permitted if the selection of the anchor point ensures
that there are no obstructions by the surrounding construction parts (building parts). Using a res-
cue winch a free path upward has to be ensured. It is not allowed to use the device if there is any
danger by surrounding constructions, moving machines or electricity.
DANGER: Wind can blow the rope towards transmission lines. Sharp edges or abrasive surfaces
can destroy the rope.
The automatic speed control of the device allows a relative safe descend. However, the device
should be used only by instructed persons, which are training regularly. On devices
having a rescue winch special attention has to be paid to arising danger from the rotating
wheel.
Please consider that environmental influences such as extreme temperatures, chemical
substances, rough and sharp edges may lower the strength of the rope. Protect the equipment
during transport by using suitable device bags or boxes.

6. REGULAR CHECKS

To ensure the safety of the user, the device has to be checked upon doubts on its function,
or at least once a year by an authorized person or the manufacturer at least once a year
(standard check). If there are any doubts concerning the safety of the device, if there are
repairs necessary, or if the device has been used, the device has to be checked by the manufactu-
rer or a repair shop which is authorized by the manufacturer (manufacturer check).
A manufacturer check is required at least after 6 years. In certain circumstances the inspection
periods can be extended where devices are part of emergency equipment and have been specially
packed and sealed. These longer inspection periods must be defined by the manufacturer on a
case to case basis, taking into account storage and packing.
The checking procedure has to be documented according to the instructions given by the
manufacturer.
Only the manufacturer according to the ANSI or EU-Type Approval permits modifications,
alterings, repairs or supplementary equipment. Infringement of this condition deletes the validity of
the operation allowance and excludes the liability insurance of the manufacturer.
Devices which fail inspecion have to be marked clearly to avoid that they are going to be
used.
37