Honda HP500H Manual De Explicaciones página 50

Temporary installation of a disengaged track
In the unlikely event that a track slips off the sprockets during
operation, proceed with the following:
1.Stop the engine (refer to page 31).
2.Remove any load in the carrier, by hand. Do not empty it by dumping
the carrier.
3.Move the power carrier to a flat surface and support on wooden
blocks in two locations (so the wheels are off the ground). Dump the
carrier.
CAUTION:
A carrier with a disengaged track will fall over if the carrier is dumped,
unless first secured with wooden blocks.
4.Loosen the track tension lock nuts and tighten up the inner nut as far
as it will go. (This is done in order to facilitate the mounting of the
track.)
5.Remove the sprocket bolts.
FRAME
LOCK NUTS
WARENCH 19
WOODEN BLOCKS
WRENCH
14×10
SPROCKET
BOLTS
47