Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Saw
Operations
Chop Cut
•
During a chop cut, the slide rail lock knob is
tightened and the head assembly is lowered to
cut through the workpiece.
•
This type of cut is used mainly for narrow pieces.
Follow these instructions for making your chop cut:
1.
Slide the head assembly to the rear as far as it
will go (Figure 26).
2.
Tighten the slide rail lock knob (Figure 26).
3.
Properly position workpiece.
Make sure work-
piece is clamped firmly against the table and the
fence.
Use clamping position that does not
interfere
with
operation.
Before
switching
on, lower head assembly
to make sure
clamp clears guard and head assembly.
4.
Activate the switch.
Lower the head assembly
and make your cut.
5.
Wait until
blade comes
to a complete
stop
before returning
head assembly
to the raised
position and/or removing workpiece.
Slide Lock
Knob Tightened
Slide Completely
Against Rest
Figure 26. Chop Cut
Slide Cut
During a slide cut, the slide rail lock knob is loose,
the head assembly is pulled towards the operator,
the head assembly is lowered to the workpiece
and then pushed to the rear of the saw to make
the cut.
This type of cut is used mainly for wide pieces.
A positive blade hook of 10 degrees or more is
recommended
for best performance when mak-
ing aggressive cuts or cutting thicker materials.
See page 36 for accessory blade listing.
NEVER pull the saw toward you during
a cut. The blade can suddenly climb
up on top of the workpiece and force itself toward you.
Follow
these
instructions
for
making
your
slide cut:
1.
Properly position workpiece.
Make sure work-
piece is clamped
firmly against the table and
the fence.
Use clamping position that does not
interfere
with
operation.
Before
switching on, lower head assembly to make sure clamp
clears guard and head assembly.
.
3.
Loosen the slide rail lock knob (figure 27).
Grasp the
switch
handle and pull the
head
assembly away from the fence, until the blade
clears the workpiece
or to its maximum exten-
sion
if blade
cannot
clear
the
workpiece
(Figure 27).
24.
4.
Activate the switch. Lower the assembly all the
way down and cut through the edge of the work-
piece.
5.
Push (but do not force) the head assembly
towards
the fence to the full rear position to
complete the cut.
6.
Wait until blade comes to a complete stop before
returning head assembly to the raised position
and/or removing workpiece.
Slide Rail
Lock Knob
Figure 27. Slide Cut
Capítulos
Tabla de contenido
