Procedure; Prepare Electrical Connection - Bosch 40 Instrucciones De Instalación

Procedure

Prepare Electrical Connection

Electrical Specifications
Check data plate for kW rating. Reference kW rating
in table to determine amperage requirements.
kW Rating
At 120/240 At 120/208
Volts Volts
12.3 9.2
12.6 9.5
13.5 10.2
* Varies by location. Refer to local electric code.
Install Ventilation
We strongly recommend the installation of a ven-
tilation hood above this range. For most kitchens
a certiied hood rating of not less than 300 CFM is
recommended. The range hood must be installed ac-
cording to instructions furnished with the hood.
Prepare Walls and Floor
Seal any holes in the walls or loor. Remove any ob-
structions (extra electrical or gas connections, etc.)
so that range will rest against wall properly.
Prepare Range
Place range in front of cabinets where it is to be
installed. Remove any packaging.
AMPS Required
US
Canadian
Models Models
40 or 50* 40 or 50*
40 or 50* 50
50 50
Install Strain Relief
WARNING
,
The strain relief provided with your range cord must
beproperly installed.
Place strain relief in knockout below terminal block.
Feed range cord through hole and strain relief up
to terminal block. Allow for slack in the cord be-
tween the strain relief and terminal block. Once cord
length/slack has been adjusted, attach strain relief
per instructions included with strain relief.
(found behind terminal block cover)
Feed range cord through strain
relief in knockout panel here.
Tip: The knockout panel (below the terminal block)
can be removed from the range to install the strain
relief: Remove panel from range, install strain relief
in panel and reattach. DO NOT remove entire range
back panel.
There are four possible electrical connections:
1. Four wire range cord
2. Three wire range cord
3. Four wire lexible conduit connection (hard wire)
4. Three wire lexible conduit connection (hard wire)
The four wire range cord connection is the recom-
mended method, but where local codes permit,
three wire connections are also acceptable.
As an alternative to the range cord, the appliance
can also be hard wired with either a three or four
wire connection. In this case, the terminal lugs sup-
plied must
be used.
Always verify that your chosen connection complies
with all applicable codes. See "Electrical Speciica-
tions" at the beginning of this manual for further
information.
Electrical connection
7