Optional Installations; Side Lock; Doormaster Tm Bracket - Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario

❉
Install the side lock on the second
Tools Needed:
section of the door. Secure the lock to
the section with (4) 1/4"- 20 x 11/16"
Power Drill
self drilling screws. Square the lock
7/16" Socket
assembly with the door section and
Driver
align with the square hole in the vertical
track. The side lock should be spaced
approximately 1/8" from the section
edge.
IMPORTANT: SIDE LOCKS MUST BE
REMOVED OR MADE INOPERATIVE IN
THE UNLOCKED POSITION IF AN
OPERATOR IS INSTALLED ON THE DOOR.
NOTE: After completing this step,
continue with Step 9 on page 15.
❉
Tools Needed:
NOTE: When installing a DoorMaster
operator use the center bracket and
None
drive gear supplied with your operator
(located in DoorMaster
Slide the DoorMaster
gear assembly onto the TorqueMaster
spring tube, so that the drive gear/center
bracket assembly are in the center of
the TorqueMaster
NOTE: After completing this step,
continue with Step 20 on page 22.
Tools Needed:
To locate the center bracket, mark the
Power Drill
header halfway between the fl agangles
1/8" Drill Bit
and level the TorqueMaster
Drill 1/8" pilot holes into header for the
7/16" Socket
lag screws. Fasten the metal bracket to
Driver
the header using (2) 1/4" x 1-1/2" lag
screws.
NOTE: After completing this step,
continue with Step 29 on page 28.
32
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com

Side Lock

TM
DoorMaster Bracket
A
TM
TM
package).
TM bracket/drive
® spring tube.
B
® spring tube.
(4) 1/4"- 20 X 11/16"
SELF DRILLING SCREWS
A
DOORMASTER
DRIVE GEAR ASSEMBLY
®
TORQUEMASTER
B
CENTER
BRACKET
BUSHING
ASSEMBLY
1/8"
TM
BRACKET/
® TUBE
(2) 1/4" X 1-1/2"
HEX HEAD LAG
SCREWS