Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 30

33 Drum Wrap Installation
Tools Needed:
Drum wraps are identified as right and
left hand.
None
To install, place the drum wrap over the
cable drum and under the idrive
disconnect cable (right hand side). Align
the outside flange over the outside edge
of the cable drum and push the drum
wrap down onto the cable drum. Repeat
for left hand side.
NOTE: Drum wraps must be installed to
prevent cable from becoming tangled.
IMPORTANT: RIGHT AND LEFT HAND
ARE ALWAYS DETERMINED FROM
INSIDE THE BUILDING LOOKING OUT.
34
Tools Needed:
KEEP HORIZONTAL TRACK
Ratchet Wrench
PARALLEL AND WITHIN 3/4"
1/2" Socket
MAXIMUM OF DOOR EDGE,
OTHERWISE DOOR COULD FALL,
1/2" Wrench
RESULTING IN SEVERE INJURY OR
DEATH. (2) Vice Clamps
Raise the door until the top section and
Tape Measure
half of the next section are in a horizontal
Level
position. Do not raise door any further
since rear of horizontal track is not yet
Hammer
supported.
WARNING
RAISING DOOR FURTHER CAN
RESULT IN DOOR FALLING AND
CAUSE SEVERE INJURY OR DEATH.
Clamp a pair of vice clamps on the vertical
tracks just above the second roller on one
side, just below the second roller on the
other side. This will prevent the door from
raising or lowering while installing the rear
support.
Using perforated angle, 5/16" x 1-5/8"
30
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
®
Rear Support
WARNING
CABLE
DRUM
CABLE
DRUM
DOOR IN THE
UP POSITION
3/4"
DOOR EDGE
HORIZONTAL
TRACK
DRUM
WRAP
DRUM
WRAP
OUTSIDE
FLANGE
VICE
CLAMPS
VERTICAL
TRACK