Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 23

21
Drive Gear Installation
Tools Needed:
Beginning with the right hand side,
lubricate entire circumference of the 36
Lubricating Oil
tooth worm gear with the lubricating oil
36 Tooth Worm
provided. Slide the 36th worm gear
Gear
onto the winding shaft splines until it
touches the flagangle.
NOTE: On single spring applications,
no drive gear is required on the left
side.
NOTE: If additional lubricating oil is
needed, use "Dura Lube
Treatment".
22
Tools Needed:
IMPORTANT: WARNING TAGS MUST BE
SECURELY ATTACHED TO BOTH END
Power Drill
BRACKETS.
3/16" Drill Bit
Slide the right hand end bracket over
7/16"
the drive gear and fasten to the
Socket Driver
flagangle using a #10 self-tapping
Phillips Head
screw. Drill 3/16" pilot holes into jamb
Screwdriver
for the lag screws. Secure end bracket
and the flagangle to the jamb using (2)
5/16" x 1-5/8" lag screws.
Repeat for left hand side.
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
®
Engine Oil
End Brackets
FLAGANGLE
CABLE
DRUM
(2) 5/16" X 1-5/8"
LAG SCREWS
CABLE
WINDING
DRUM
SHAFT
SPLINES
LUBRICATING
OIL
36 TOOTH
WORM GEAR
36 TOOTH
WORM GEAR
WINDING
SHAFT
END BRACKET
WARNING
#10 PHILLIPS
HEAD
SCREW
TAG
23