Wayne Dalton 9100 Instrucciones De Instalación Y Manual Del Propietario página 22

20
Cable Drum Installation
Tools Needed:
Shake the TorqueMaster
gently to extend the winding shafts out
None
about 5" on each side. For single
spring applications, there will be no left
hand spring in the TorqueMaster
spring tube.
Lift the TorqueMaster
rest it on the top of the flagangles.
Orient TorqueMaster
that back of opener is flat against
header/mounting surface.
NOTE: Cable drums are marked right
and left hand. Cable drums and
TorqueMaster
shaped to fit together only one way.
To install the cable drum, slide the
correct cable drum over the winding
shaft until the cable drum seats against
the TorqueMaster
winding shaft must extend past the
cable drum far enough to expose the
splines and the groove. Align the
winding shaft groove with the round
notch in the flagangle.
For Double Spring Applications:
Repeat for opposite side.
For Single Spring Applications: Insert
the loose winding shaft into the left
hand cable drum prior to sliding the
cable drum over the TorqueMaster
spring tube.
NOTE: On single spring applications,
take care in handling the loose winding
shaft (left side) so that it does not slide
back into the TorqueMaster
tube.
22
Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer, refer to your
local yellow pages/business listings or go to the Find a Dealer section online at www.wayne-dalton.com
®
spring tube
®
®
spring tube and
® spring tube so
® spring tube are cam
®
spring tube. The
®
®
spring
TORQUEMASTER ®
SPRING TUBE GROOVE
WINDING
SPLINES
SHAFT
RIGHT HAND
CABLE DRUM
TORQUEMASTER ®
SPRING TUBE
®
TORQUEMASTER
SPRING TUBE
Left Hand Side
Single Spring Application
LEFT HAND
CABLE DRUM
COUNTERBALANCE
CABLE
FLAGANGLE
CABLE
DRUM
WINDING
SHAFT
GROOVE
FLAGANGLE
ROUND
NOTCH
WINDING
CABLE
DRUM
GROOVE
TORQUEMASTER
ROUND
SPRING TUBE
NOTCH
LOOSE
WINDING
SHAFT
ROUND
NOTCH
SHAFT
®