Mettler Toledo IND780 Guia De Instalacion página 39

Figure 2-11 shows the brackets attached to an enclosure. Note the orientation of the enclosure
relative to the brackets.
2.9.1.3.1. Marking Mounting Hole Position
Mark the position of the mounting holes on the vertical surface per the dimensions shown in Figure
2-12 in inches and [mm], or by holding the terminal up to the surface and marking through the
bracket holes.
Once the mounting hole positions are established, perform one of the following procedures,
depending on the type of wall surface.
CAUTION: When carrying out the following procedures, wear proper bodily protection, such as
64063214 | 07 | 02/2018
Figure 2-11: Attaching the Wall-Mounting Brackets
Note: The hardware to mount the terminal to the vertical surface is not included with the
terminal – it must be supplied locally. Ensure that the mounting hardware is capable of
supporting the weight of the terminal, which is approximately 11 lb (5 kg).
approved safety goggles, ear protectors and gloves.
METTLER TOLEDO IND780 Division 2 and Zone 2/22 Installation Guide
Figure 2-12: Mounting Hole Pattern
Brackets
2-19