Level One Programming: Functions; Level Two Programming: Parameters - Nice MC424 Instrucciones Y Advertencias Para La Instalación Y El Uso

5.3.1 - Level one programming: functions

At level 1, the functions can be enabled or disabled. At level one, LED P1 is
always on; if LEDs L1, L2...L5 are on, the functions are activated; if the LEDs
are off, the functions are deactivated. A flashing LED indicates which function
01. Press and hold down buttons P1 and P2 for at least 3 seconds
The programming mode has been entered if all the Leds start flashing quickly
01. Press P1 repeatedly until the flashing Led reaches the function required
02. Press P1 repeatedly until the flashing Led reaches the function required
01. Press P3. button
01. Press P1 and then immediately P2, holding them both down for at least 3 seconds
01. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply

5.3.2 - Level two programming: parameters

The function parameter can be chosen at level two. Level two can only be
01. Enter level one programming by pressing P1 and P2 for at least 3 seconds
02. Select the function by pressing P1 until the flashing Led reaches the point required
03. Enter level two by pressing the P2 button for at least 3 seconds
01. Press P2 repeatedly until the Led reaches the desired parameter
01. Press P1
01. Press P1 and then immediately P2, holding them both down for at least 3 seconds
01. Either press P1 for at least 3 seconds, or wait for 1 minute, or disconnect the power supply
6 – English
TABLE A1 - Entering level one programming
TABLE A2 - Activating or deactivating a function
TABLE A3 - To pass from part one to part two of level one (and vice-versa)
TABLE A4 - To exit level one and save the modifications
TABLE A5 - Exiting level one and delete the modifications
TABLE B1 - Entering level two programming
TABLE B2 - Selecting the parameter
TABLE B3 - Returning to level one
TABLE B4 - Exiting level one and saving modifications
TABLE B5 - Exiting level one and cancelling modifications
has been selected, short flashes indicate the function has been deactivated;
long flashes indicate the function has been activated. Press P3 to pass from
part one programming to part two programming, and vice-versa.
reached from level one. At level 2 the P1 Led flashes quickly while the 5 Leds
(L1, L2...L5) indicate the selected parameter.
P1 P2
P1
P2
P3
P1 P2
3 s
P1
3s or 60s
or
P1 P2
3 s
P1
P2
3 s
P2
P1
P1 P2
P1
3s or 60s
or