mabe MMI12CABWCAAXM8 Manual Del Propietário página 48

48
9.
clean button
a. When remote controller is at the off state, press "clean" button,
the wind guiding bars turn to initial postions for cooling, the A/C
runs clean function with max duration 35mins.The purpose of
this function is to clean dust on evaporator and dry the inside
water of evaporator and to prevent the evaporator going moldy
due to water deposition and boasting strange smell.
b. After setting clean function, press "clean" button again to
cancel "clean" function or press "on/off" button to cancel
"clean" function and start A/C.
c.
The clean function will be stop working after 35 minutes running
working without any operation.
note:
"clean" function can be set in parallel with time start function; in this
case , time start function will be executed after "clean" function.
10.
mode button
Which enables you to select different operation mode, after each
pressing, the operation mode will be changed. It shows in the
following display.
Remark: cold wind type has no heating function.
11. sleep button
a
Press the "sleep" button, the sleeping indicator light of
indoor unit flashes on.
b.
After the setting of sleeping mode, the cooling operation
enables the set temperature to increase 1ºC after 1hour
and another 1ºC automatically after 1 hour.
c. After the setting of sleeping mode, the heating operation
enables the set temperature to drop 2ºC after 1hour and
another 2ºC automatically after 1 hour.
d. The air-conditioner runs in sleeping mode for 7 hours and
stops automatically.
Remark: press the MODE or ON/OFF button, the remote
controller clears sleeping mode away.
12. swing button
Press this button, the horizontal wind direction vanes can swing
automatically, when you have the desired vertical wind direction,
press it again, the horizontal wind direction vanes will be stopped
at the situation of your choice.
13.
dust button
This button is invalid.
14.
fungus proof button
This A/C has special dry and anti-mold function which has " yes
"or " no" two selections. This function is controlled by the remote
controller under cooling, dry and auto (cooling and dry) modes,
the horizontal wind guiding bars are at the initial position for
AUTO COOL DRY HEAT FAN AUTO