THE POWER SUPPLY CIRCUIT SHOULD HAVE LEAKAGE
PROTECTOR AND AIR SWITCH OF WHICH THE CAPACITY
SHOULD BE MORE THAN 1.5 TIMES OF THE MAXIMUM
CURRENT.
REGARDING THE INSTALLATION OF THE AIR CONDITIONERS,
PLEASE REFER TO THE BELOW PARAGRAPHS IN THIS MANUAL.
notices for use
the conditions of unit can't normally run
Within the temperature range provided in following table, the air
conditioner may stop running and other anomalies may arise.
outdoor
cooling
indoor
outdoor
heating
indoor
When the temperature is too high, the air conditioner may activate
the automatic protection device, so that the air conditioner could be
shut down.
When the temperature is too low, the heat exchanger of the air
conditioner may freeze, leading to water leakage or other
malfunction.
above 80% (doors and windows are open), there may be water
condenses or dripping near the air outlet.
T1 and T3 refer to ISO 5151.
notes for heating
The fan of the indoor unit will not start running immediately after the
heating is started to avoid blowing out cool air.
When it is cold and wet outside, the outdoor unit will develop frost
over the heat exchanger which will compromise the heating capacity.
This is when the air conditioner will start defrost.
>
43 ˚C (apply to T1)
>
52 ˚C (apply to T3)
<
18 ˚C
24
>
˚C
-7
>
˚C
27
>
˚C
43