Step 7: Prepare The Receiver Collar - Petsafe PIG19 Manual Del Producto

Step 7: Prepare the Receiver Collar

In order to test the system you will need to use the receiver collar. Your receiver
collar comes installed with short contact points. If your pet has long or thick hair,
use the long contact points instead. Tighten or switch the contact points by using
the test light tool (7A).
Turn the Receiver Collar On
To turn on the receiver collar, press and hold the mode button continuously for
5 seconds (7B). The receiver indicator light will turn on for 5 seconds to indicate
battery status (green, yellow or red), followed by a series of red flashes which
represent the static stimulation level.
Turn the Receiver Collar Off
To turn off the receiver collar, press and hold the mode button continuously for
5 seconds (7B). The red receiver indicator light will be on during this time. The red
receiver indicator light will then turn off and all receiver indicator lights will stay
off indicating that the unit is turned off. To extend the time between charging the
receiver collar, consider turning off the receiver collar when it is not in use.
Receiver Collar Status Indicators
The receiver collar status indicator light, along with the receiver collar alarm
tone, are used to determine the battery status and the stimulation type. Refer to
the receiver collar status indicator table below to understand the status lights and
tones for the receiver collar. During normal operation, the receiver collar indicator
light will flash every 4–5 seconds to indicate the battery status as shown in the following table.
Light Status
Solid red
Solid green
No light
Continuous green, yellow or red
(5 seconds duration)
Slow blinking green
(every 4–5 seconds)
Slow blinking yellow
(every 4–5 seconds)
Slow blinking red
(every 4–5 seconds)
Fast pulsating green
(3 flashes per second)
Fast pulsating red
(3 flashes per second)
Continuous green
(10 seconds)
14
Receiver Collar Status Indicator Table
Alarm Tone
While Plugged into the Receiver Charger
No tone
No tone
–
After Removing from the Receiver Charger
No tone
Operating Battery Status
No tone
No tone
No tone
Receiver Activation Status
Warning tone
Tone for duration of static
stimulation
No tone
petsafe.com
7A
7B
Receiver Indicator Light
Condition
Charge in progress
Charge complete
Charge failure, contact
Customer Care Centre
Battery charge indication;
Occurs immediately after
unplugging the charger from the receiver collar
Collar battery charge 100%–60%
Collar battery charge 60%–20%
Collar battery charge 20% or less, charge immediately
Warning tone
Static stimulation being delivered up to 15 seconds
Over-stimulation protection; collar locked for 10 seconds
Mode Button/