Prepare The Receiver Collar; Charge The Receiver Collar - Petsafe PDT20-10715 Manual De Adiestramiento Y Funcionamiento

Step

Prepare the Receiver Collar

2

Charge the Receiver Collar

1. Lift the rubber cover protecting the Receiver Collar
Charging Jack.
2. Connect one of the charger connectors to the
Receiver Collar Charging Jack.
3. Plug the charger into a standard wall outlet.
4. Charge the Receiver Collar for 24 hours for the
fi rst charge. Recharges take only 12 hours.
Note: The Receiver Indicator Light will fl ash after
12 hours of charging. For the fi rst charge, continue to
charge the Receiver Collar for an additional 12 hours.
5. When charging is completed, replace the rubber
cover.
To Turn the Receiver Collar On:
1. Press and hold the On/Off Button until the
Receiver Indicator Light comes on
and the Receiver Collar beeps 5 times.
2. Release the On/Off Button.
The Receiver Indicator Light will fl ash until the
Receiver Collar is turned off. The fl ashing light
indicates the Receiver Collar is ready to receive a
radio signal from the Remote Transmitter.
To Turn the Receiver Collar Off:
1. Press and hold the On/Off Button until the Receiver Indicator Light comes on and
the Receiver Collar beeps 2 times.
2. Release the On/Off Button.
To extend the life between charging cycles, turn the Receiver Collar off when it is not in
use. Approximate battery life between charges is 20 hours, depending on frequency of use.
6 www.petsafe.net
Charger connector
placed in Receiver
Collar Charging
On/Off Button
Jack