Step 6: Prepare The Receiver Collar; To Insert And Remove The Battery - Petsafe PIG19 Manual Del Producto

Step 6: Prepare the Receiver Collar

There are two sets of contact points that can be used on your
receiver collar. Your receiver collar comes with the short contact
points installed. The longer contact points should be used on dogs
with long hair. Tighten the contact points using test light tool (6A)
one-half turn beyond finger tight. Check the tightness weekly.

To Insert and Remove the Battery

Note: Do not install the battery while the receiver collar is on
your pet.
This receiver collar utilises a replaceable PetSafe
(RFA-67D-11). This unique battery is designed to make battery
replacement easier and increase water protection.
To insert the battery, align the symbols on the battery (arrow) and
receiver collar (triangle). Use the edge of the test light tool to turn the
battery clockwise until the arrow lines up with the lock symbol on the
housing (6B).
To remove the battery, turn the battery anti-clockwise using the
edge of the test light tool (6C). Do not attempt to cut into or pry open
the battery. Be sure to discard the used battery properly. The battery
life will vary depending on how often your pet tests the system and
receives a static stimulation. Check the receiver collar every month
to ensure the battery is working properly.
If the receiver indicator light is flashing every 4 to 5 seconds, battery
replacement is required. Remove the old battery from the receiver
collar. Discharge all power by holding the stimulation level button
down until the LED light is no longer illuminated. Replace with a
new battery.
A replacement PetSafe
contacting the Customer Care Centre or by visiting our website at
www.petsafe.com.
To Set the Static Stimulation Level
Read all steps before attempting to set the static stimulation level.
1. Remove the clear plastic cover with the test light tool to expose
the stimulation level button (6D).
2. With the battery installed, press the stimulation level button and
release when the receiver indicator light turns on (6E).
3. The receiver indicator light will emit a series of flashes
representing the static stimulation level (e.g., 4 red flashes
means level 4).
4. Increase the static stimulation level by pressing and releasing the
stimulation level button within 5 seconds of the previous series
of flashes.
5. After setting the static stimulation level, replace the cover to
protect the stimulation level button.
14
battery (RFA-67D-11) can be purchased by
®
battery
®
petsafe.com
6A
6B
6C
6D
6E