Petsafe PIG19 Manual Del Producto página 3

• Wire on top of the ground may be a trip hazard. Be careful when placing wires and testing the system.
• This product is not a toy. Keep it away from the reach of children.
• This PetSafe Basic In-Ground Fence
®
to remind pets to remain within the established boundary by use of static stimulation. It is important that
you reinforce training with your pet on a regular basis. Since the tolerance level to static stimulation
varies from pet to pet, Radio Systems Corporation CANNOT guarantee that the system will, in all cases,
keep a pet within the established boundary. Not all pets can be trained to avoid crossing the boundary!
Therefore, if you have reason to believe that your pet may pose a danger to others or harm himself if
he is not kept from crossing the boundary, you should NOT rely solely upon this system to confine your
pet. Radio Systems Corporation shall NOT be liable for any property damage, economic loss or any
consequential damages sustained as a result of any animal crossing the boundary.
• Proper fit of the receiver collar is important. A receiver collar worn for too long or made too tight on the
pet's neck may cause skin damage, ranging from redness to pressure ulcers; this condition is commonly
known as bed sores.
• Avoid leaving the receiver collar on the pet for more than 12 hours per day.
• When possible reposition the receiver collar on the pet's neck every 1 to 2 hours.
• Regularly recheck the fit to prevent excessive pressure; follow the instructions in this product manual.
• Never connect a lead to the receiver collar. It will cause excessive pressure on the contact points.
• When connecting a lead to a separate collar, do not allow it to put pressure on the receiver collar.
• Wash the pet's neck area and the contact points of the receiver collar weekly with a damp cloth.
• Examine the contact area daily for signs of a rash or a sore.
• If a rash or sore is found, discontinue use of the receiver collar until the skin has healed.
• If the condition persists beyond 48 hours, see your veterinarian.
• For additional information on bed sores and pressure necrosis, please visit our website.
• You may need to trim the hair in the area of the contact points. However, never shave the pet's neck; this
may lead to a rash or infection.
• The boundary width of the system must be tested whenever an adjustment is made to the pet area to
prevent unintended stimulations to your pet.
• Always remove your pet's receiver collar before performing any transmitter testing or adjustments. This
will prevent unintended static stimulations.
• If possible, do not use an outlet protected with a residual current device (RCD) or a ground fault circuit
interrupter (GFCI). The fence system will function, but in rare cases, nearby lightning strikes may cause
the RCD or GFCI to trip. Without power, your pet may be vulnerable to escape. You will have to reset the
RCD or GFCI to restore power to the system.
• Proper training of your pet is essential to successfully using the system. During the first 2 weeks of
training, do not use the system without direct supervision of your pet.
• Before you begin installing the boundary wire, unplug the fence transmitter.
• Avoid damaging the insulation of the loop wire; damage may cause areas of weak signal and lead to
failure of the boundary.
• Use care when mowing or trimming your grass not to cut the boundary wire.
• To protect the transmitter, disconnect the boundary wire and unplug the power adaptor from the outlet
when the system will not be used for long periods of time or prior to thunderstorms. This will prevent
power surges from damaging the transmitter.
System is NOT a solid barrier. It is designed to act as a deterrent
™
petsafe.com 3