Petsafe PIG19 Manual Del Producto página 11

Double Loop Boundary
• To section off only one boundary area or one
section of your garden (e.g., front property
only, or waterfront property)
• The 2 parallel sections of the double
boundary wire must be separated by a
minimum of approximately 1.5 m from
each other in order to avoid cancelling out
the signal as well as provide an adequate
boundary width (3E)
• A double loop layout requires twice as
much wire as a single loop layout because it
doubles back along the same path
With a double loop layout, the boundary wire
starts at the fence transmitter, advances out to the
garden and continues to form a boundary zone in
one section of your property (e.g., front property
only). Then the wire makes a U-turn back along
the same path and connects back to the fence
transmitter. This forms a boundary zone with a
double wire.
Sample 3: Front Property or Back Property
Only (3E)
From the fence transmitter, run the wire to point A,
then to point B and so on (B to C to D to E to F).
Next, make a U-turn and follow your path all the
way back to point G, keeping the wire separated
by at least 1.5 m. When you get back to the house
(G), make a sharp turn along the side of the house
back to point A. Finally, twist the wires from point
A and connect them back to the fence transmitter.
Sample 4: Front Boundary Only (3F)
From the fence transmitter, run the wire to point
A, then to point B. Make a U-turn and follow your
path back to point A, keeping the wire separated
by at least 1.5 m. Then twist the wires from point A
and connect them back to the fence transmitter.
Sample 5: Waterfront Property (3G)
From the fence transmitter, run the wire to point
A, then to point B. Make a U-turn and follow your
path to C, then to D, then to E. Next, make another
U-turn and follow the same path all the way back
to point A, keeping the wire separated by at least
1.5 m. Finally, twist the wires from point A and
connect them back to the fence transmitter.
Sample 6: Wire Loop Attached to Existing
Fence (3H)
This layout allows you to include your existing
fence as part of your layout and keep your pet
from jumping out or digging under your existing
fence. It reduces the amount of wire which will
need to be buried. From the fence transmitter run
the wire to point A, then to point B and so on (B to
C to D to E to F). Next, make a U-turn and follow
your path all the way back to point A, keeping the
wire separated by at least 1.5 m. Finally, twist the
wires from point A back to the fence transmitter.
3E
1.5 m
C
G
A
Place Transmitter Inside
3F
3G
3H
petsafe.com
D
G
A
B
E
F
11