baltur TBML80 PN Manual De Instrucciones página 27

TBML 80 PN MAINTENANCE
Periodically analyze combustion gases and check emissions val-
ues.
Periodically replace the diesel fuel and gas filters when dirty.
Check that all components of the combustion head are in good
condition, have not been deformed by high temperatures and con-
tain no impurities or deposits from the installation environment or
from poor combustion; check the efficiency of electrodes.
If it is necessary to clean the outside of the combustion head, take
out its components according to the procedure described below:
1) Disconnect the diesel fuel 1 pipes from the connectors beneath
the combustion head (be careful of drips)
2) Unscrew screws 2 (No.4) and turn the burner around pin 3 in
the hinge (figure 1).
3) After pulling the ignition cables 4 out of their electrodes, com-
pletely unscrew the locking nuts 5 (No.2) from mixing unit.
Loosen nut 6 and completely unscrew the fastening screw on
the delivery coupling 7. With the same wrench turn the ball joint
(6) in the direction indicated with the arrow, unhooking the lever
that moves the combustion head forward (see figure 3).
4) Slightly lower the gas delivery connection (9) (figure 4) and re-
move the entire mixing unit in the direction indicated by the
arrow in figure 4.
5) Complete the maintenance work; replace the combustion head,
following in reverse order the operations above described, after
having checked the correct position of the electrodes of ignition
and of ionization (see 0002936380).
On closing the burner, gently pull the two ignition cables
!
toward the electrical panel, so that they are rather taut, and
then arrange them in their places (7) as in figure 2. This will
ensure that the two cables do not get damaged by the fan
while the burner is on.
figure 1
23 / 28
0006081470_201105
E
N
G
L
I
S
H
figure -2
figure -3
figure -4