Focus The Scanner; Reset The Timecode - Blackmagic Design Cintel Manual De Instalación Y Funcionamiento

Focus the Scanner

Just as you need to focus the lens on a camera, you'll need to focus the projected film image
on your scanner's sensor. To achieve perfect focus, turn on the Focus Assist checkbox in the
Film Scanner capture settings of DaVinci Resolve. This superimposes a focus peaking overlay
over the Ultra HD image that's output from the scanner's HDMI output, and is also displayed in
DaVinci Resolve's capture window. For the best results, connect an Ultra HD display to your
Cintel scanner so that you can monitor at the maximum available resolution while you focus.
With Focus Assist turned on, focus peaking will detect the film grain of the scanned image
whenever the film plane is in perfect focus. This enables the operator to focus the scanner
even if the film image is out of focus. Simply monitor the Ultra HD output of the scanner while
you turn the Cintel scanner's focus wheel. Your image will be in focus when the grain running
throughout the image displays peaking outlines.
TIP You can verify the focal adjustments you've made by checking the edges of your
film's perforations. When these are sharp, your film will be in focus.

Reset the Timecode

To set the timecode for the roll of film you're about to scan, you need to locate the zero frame for
that roll. It's standard practice to punch a small physical hole within the frame before the first frame
of necessary film on a roll, to use as a permanent reference for whenever that roll is scanned. This is
referred to as the marker frame, lab roll hole, or head punch. By always setting the first frame of
timecode to match the marker frame, subsequent film scans will have the same frame count as
previous scans, making it possible to rescan and reconform the same material whenever necessary.
To reset scanned timecode at the marker frame of a new film roll:
1 Use the transport controls under the viewer to locate the marker frame.
2 Click the 'viewer' option menu and choose 'current frame timecode.'
Choosing Current Frame Timecode
from the Viewer Option menu
3 Enter a timecode value in the dialog box that appears. For example, if you're scanning
the first roll of a project, you can enter 01:00:00:00.
The Set Current Frame Timecode dialog
4 When you're done, click OK.
Capturing from Cintel using DaVinci Resolve 31