Important - TRAPP TRR 180 Manual De Instrucciones

www.trapp.com.br
Attention!
Read all instructions herein before operating
the equipment. Always observe and follow
safety instructions to prevent accidents and/
or injuries.
The Residues Shredders models TRR 180/190
are designed to shred residues of pruning wood
waste, branches, clippings, shrubs, and wood
piles up to 4 cm in diameter.
The TRR 250/260 models are designed to shred
wood up to 7 cm in diameter and TRR 280 up to
8 cm in diameter.
Both also can shred packaging waste or other
wood structures without nails, wire and other
metals. Any other use jeopardizes the integrity of
the machine and operator safety.

Important:

Recently trimmed material must dry a little
before being shredded. It increases the
performance of the shredder, providing better
residue composting.
The equipment must be installed in an open,
 
well-ventilated environment on solid, flat
ground.
Keep children and spectators away. People,
 
especially children, must remain at a safe
distance from the working area - 30 m -
when the equipment is being used. The
operator/user is responsible for accidents that
may occur.
Do not allow people to touch the machine
 
while being used or transported.
Shredder Usage
Do not lubricate, clean or adjust movable
 
components while they are moving or when
the machine is being lifted.
When maintaining or adjusting the
 
equipment, do not use your hands in
operations that can be done with specific
tools.
Do neither use bad tools nor use them
 
inadequately (e.g. pliers instead of wrenches,
etc.).
Before servicing hydraulic lines under
 
pressure, switch their components off,
making sure the line is not under pressure
and the liquid in not hot.
After maintenance or repair, make sure tools,
 
cloths or other materials/objects were not left
inside gaps or guides with movable parts.
When using the equipment, only one person
 
must give instructions and signalize the
direction of loads.
Maximum diameter of branches according
 
to the supported diameter of the product,
that means on TRR 180/190 model Ø 4 cm,
TRR 250/260 model Ø 7 cm and TRR 280
Ø 8 cm.
Remove weird objects such as metal, glass or
 
stones before turning machine on.
Just remove protection lid when machine
 
comes to a stop.
Turn shredder on and wait for maximum
 
revolution to be reached to insert materials.
TRAPP is not responsible for damages caused
 
due to failure to observe the instructions in
this manual.
55