Tabla de contenido
Idiomas disponibles
Idiomas disponibles
www.trapp.com.br
Connect the parts of cardan and couple it to
tractor.
Secure protection retention chains. The ideal
operation condition is obtained with the
chain placed radial to transmission. Adjust
the length of chains to allow transmission
to be articulated under any working,
transportation and maneuvering condition.
Make sure chains do not entangle around the
transmission due to excessive length.
Before starting to work, make sure cardan
transmission is properly secured to the tractor
and equipment. Check whether securing
screws are properly tightened.
Note:
The pieces cut from the solid and tubular
parts of the cardan shall have the same
length.
Allow at least 2.5 cm on each end of the
cardan.
Do not use the chains to transport or
support cardan transmission when work
is done. Use proper support.
When transporting transmission, keep
it in horizontal position to prevent parts
from getting apart, causing accidents
or damaging protection guard. Use
transportation means adequate to the
weight of the transmission.
2.5 cm
clearance
When at maximum opening, plastic safety
protections and shafts must be superimposed
at least 1/3 of their length (LT). When at
maximum closing, the minimum gap allowed
is 1 to 2 cm (Figure 1). Keep terminals
aligned.
61
Tabla de contenido
