Key To Symbols; Symbols On The Machine And/Or In The Manual - Husqvarna 435 Manual De Instrucciones

KEY TO SYMBOLS
Symbols on the machine and/or in
the manual:
WARNING! Chain saws can be
dangerous! Careless or improper use
can result in serious or fatal injury to the
operator or others.
Please read the operator's manual
carefully and make sure you
understand the instructions before
using the machine.
Always wear:
Approved protective helmet
Approved hearing protection
Protective goggles or a visor
Q
Both of the operator's hands must be
used to operate the chain saw.
Never operate a chain saw holding it with _k_
one hand only.
Contact of the guide bar tip with any
object must be avoided.
WARNING! Kickback may occur when
the nose or tip of the guide bar touches an
object, and cause a lightning fast reverse
reaction, kicking the guide bar up and
towards the operator. May cause serious
personal injury.
@
.dl.=,_ _ ,,,,=.,,k_
Chain brake, activated (right) Chain "_ _
brake, not activated (left)
CO)/O
Decompression valve: Press the
valve to reduce the pressure in the ,_
cylinder and make starting easier. You
should always use the decompression
DZu
valve when starting the machine.
mgnition; choke: Set the choke control
in the choke position.This should I _\ _ I
automatically set the stop switch to the
start position.
Adjustment of the oil pump +f_L
Other symbols/decals on the machine
refer to special certification requirements for certain
markets.
Switch off the engine before carrying
out any checks or maintenance. NB,
i Voi
The start/stop switch automatically
returns to run position. In order to
prevent unintentional starting, the
spark plug cap must be removed from the spark plug
when assembling, checking and/or performing
maintenance.
gloves.Always wear approved protective
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be I I
worn.
Refuelling.
Filling with oil and adjusting oil flow.
The chain brake should be activated
when starting.
For Canada only:
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
_ _ MaXlOT
Other approved bar and chain
combinations in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination
on the label.
Measured maximum kickback value
without triggering the brake, for the bar
and chain combination on the label.
1153135-49 Rev.6 2013-12-09 English - 7