Safety Instructions; Basic Information Concerning Safety; Electromagnetic Compatibility - Hilti PD 40 Manual De Instrucciones

Technical data
Storage temperature
Protection class (except battery compartment)
Weight without batteries
Dimensions
en
Menu / units
m
cm
mm
In
In ¹/₈
In ¹/₁₆
In ¹/₃₂
Ft
Ft ¹/₈
Ft ¹/₁₆
Ft ¹/₃₂
Yd

5 Safety instructions

In addition to the information relevant to safety given
in each of the sections of these operating instructions,
the following points must be strictly observed at all
times.

5.1 Basic information concerning safety

a) Do not render safety devices ineffective and do
not remove information and warning notices.
b) Keep laser tools out of reach of children.
c) Failure to follow the correct procedures when open-
ing the tool may cause emission of laser radiation in
excess of class 2. Have the tool repaired only at a
Hilti service center.
d) Check that the tool functions correctly each time
before use.
e) Operation of the tool in the proximity of pregnant
women is not permissible.
f) Measurements taken from surfaces with low reflectiv-
ity in highly reflective surroundings may be inaccur-
ate.
g) Measurements taken through panes of glass or other
objects may be inaccurate.
h) Rapid changes in the conditions under which the
measurement is taken, e.g. persons walking through
the laser beam, may lead to inaccurate results. i) Do not point the tool toward the sun or other
powerful light sources.
20
Distance
Meters
Centimeters
Millimeters
Inches, decimal
¹/₈ inch
¹/₁₆ inch
¹/₃₂ inch
Feet, decimal
Feet-inches-¹/₈
Feet-inches-¹/₁₆
Feet-inches-¹/₃₂
Yards, decimal
Values
-30...+70°C
IP 54 protection against dust and water jets
IEC 529
170 g
120 mm x 55 mm x 28 mm
Area
m²
m²
m²
Inches²
Inches²
Inches²
Inches²
Feet²
Feet²
Feet²
Feet²
Yards²
5.2 Proper organization of the workplace
a) Avoid unfavorable body positions when working
from ladders. Make sure you work from a safe
stance and stay in balance at all times.
b) Check the measuring reference setting before
taking the measurement.
c) When the tool is brought into a warm environment
from very cold conditions, or vice-versa, allow it
to become acclimatized before use.
d) As a precaution, check the previous settings and
adjustments you have made.
e) When setting up the tool with the aid of the bubble
level, view the bubble level at a slight angle.
Secure the area in which you are working and
f)
take care to avoid directing the beam towards
other persons or towards yourself when setting
up the tool.
g) Use the tool only within its specified limits.
h) Observe the accident prevention regulations ap-
plicable in your country.

5.3 Electromagnetic compatibility

Although the tool complies with the strict requirements of
the applicable directives, Hilti cannot entirely rule out the
possibility of the tool being subject to interference caused
by powerful electromagnetic radiation, leading to incor-
rect operation. Check the accuracy of the tool by taking
measurements by other means when working under such
Volume
m³
m³
m³
Inches³
Inches³
Inches³
Inches³
Feet³
Feet³
Feet³
Feet³
Yards³