Service And Maintenance; Accessories - Festool KS 60 E KAPEX Manual De Instrucciones Original

KS 60 E
GB
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the mains plug from the
socket before performing maintenance work on
the machine!

All maintenance and repair work which requires
the motor housing to be opened must only be
carried out by an authorised service workshop.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
EKAT
Only use original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
Regular cleaning of the machine, above all
the adjustment devices and the guides, is an
important safety factor.
Damaged safety devices and components
must be repaired or replaced in a recognised
specialist workshop in accordance with reg-
ulations, unless otherwise indicated in the operat-
ing manual.
Observe the following instructions:
– To ensure constant air circulation, always keep
the cooling air openings in the housing clean and
free of blockages.
– Use an extractor on all openings of the power
tool to remove wood chips and splinters. Sawing
chips and small parts that get caught up in the
sawing channel can be gently pulled out through
the opening [12-4].
– The machine is equipped with special self-dis-
connecting carbon brushes. If they are worn, the
power is interrupted automatically and the ma-
chine comes to a standstill.
9.1 Replacing the chip deflector [12]

To ensure that dust and chips are collected
properly, you must only work if a chip deflector
is installed.

Undo the screws [12-1] on the guard, remove
the chip deflector and clamp.

Attach the clamp [12-2] to the new chip deflec-
tor.
26

Screw the chip deflector [12-3], along with the
clamp, onto the guard.
9.2 Replacing the tabletop insert [13]
Always replace worn tabletop inserts. Never use
the machine without tabletop inserts.

Unscrew the position marking [10-3] for the
bevel.

Undo the screws [10-1] in the tabletop insert.

Replace the tabletop insert [10-2] and position
marking [10-3].

Reattach the screws.

Check that the position markings
line that, at the same time, must run at a right
angle to the stop rulers.
9.3 Cleaning/replacing the spotlight window
(available as an accessory depending on the
model
The spotlight SL-KS60 lights up the cutting edge on
the workpiece. Dust-intensive work may affect the
power of the light. Proceed as follows to clean the
spotlight [13]:

Move the machine into the working position.

Pull out the spotlight window [10-4] by hand,
and clean/replace it.

Reinsert the spotlight window.
The spotlight window audibly clicks into place.

10 Accessories

The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
In addition to the accessories described, Festool
also provides a comprehensive range of system ac-
cessories that allow you to use your saw more ef-
fectively and in diverse applications, e.g.:
• Trimming attachment KA-KS60
• Base frame UG-KAPEX KS 60
• Screw-in feet A-SYS-KS60
• Clamping connection for MFT SZ-KS
• Bevel SM-KS60
• Spotlight SL-KS60
10.1 Bevel SM-KS60 (available as an accessory
depending on the model)
The bevel can be used to gauge any angle (e.g. be-
tween two walls). The bevel therefore forms the an-
gle bisection.
Gauging the interior angle [14A]

Open the locking device [14-2].
lie on a