Acoustic Warning Signals; Service And Maintenance; Accessories - Festool CARVEX PSC 420 EB Manual De Instrucciones Original

up to approx. 2100 rpm: continuous light
from approx. 2100 rpm: stroboscope light

In overhead position (+/- 45°), the lighting is
switched off completely.
If required, you can adjust the lighting:
 Plug in the electric power tool.

Press both buttons simultaneously [1-2] and
hold for approx. 10 s until a beep sounds.

Release both buttons [1-2].

Press the left button (on the pendulum stroke
side) to select the stroke speed and conse-
quently the desired operating mode:
Mode Indication during
configuration
1 Light flashes
2 Light on
3 Light off

Press the right button to save the setting.
8.2

Acoustic warning signals

Acoustic warning signals sound and the machine
switches off in the following operating states:
Battery flat or machine over-
loaded.
– Change the battery.
– Place the machine under reduced
stress.
Machine is overheating.
– You must allow the machine to
cool before using again.
LiIon battery pack is faulty or has
overheated.
– Once the battery pack has cooled,
perform a functional check using
the charger.
9

Service and maintenance

WARNING
Risk of injury, electric shock

Always disconnect the battery pack from the
machine before any maintenance or care work!

All maintenance and repair work which requires
the motor housing to be opened, must only be
carried out by an authorised service workshop.
All manuals and user guides at all-guides.com
EKAT
Damaged safety devices and components must be
repaired or replaced in a recognised specialist
workshop, unless otherwise indicated in the oper-
ating manual.
Behaviour
during operation
Observe the following instructions:
– Keep the air slits on the machine and the charger
With stroboscope
(standard)
– Keep the contacts on the machine, charger and
Permanent light
without strobo-
scope
– Check the guidance roller regularly for wear.
Light switched off – Regularly remove dust deposits from the chip
– Regularly clean the base runner to prevent
Information on battery packs
– Store in a cool, dry place at a temperature be-
– Protect battery packs from moisture, water and
– Do not leave flat battery packs in a charger dis-
– If you intend to store li-ion battery packs for lon-
– To avoid short circuits the battery pack should be
– Significantly shorter operating times after each
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
10.1
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all applica-
tions that are specially designed for your Festool
jigsaw.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Use only original Festool spare parts!
4
Order No. at: www.festool.com/service
5
3
2
1
free and clean to ensure adequate cooling.
battery pack clean.
guard.
scratches and cores on the surface.
tween 5 °C and 25 °C.
heat.
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
ger periods without use, you should charge them
to 40 % capacity (approx. 15 min charging time).
stored in the packaging supplied.
charge indicate that the battery pack is worn and
should be replaced with a new one.
10

Accessories

Saw blades, other accessories
PSC 420 EB GB
21