Ingersoll Rand UP5S 11 Instalación, Operación Y Mantenimiento página 9

OPERATING INSTRUCTIONS (XE-70M CONTROLLER)
Table 3 : Display Layout
Key Name Description
A Folder Bar Uses tabs to graphically identify
each folder��
B Title Bar Identifies current folder and page
(underlined)��
C Page Content of the current page��
Content
D Dashboard Displays system status��
FOLDER NAVIGATION AND ICONS

To move among the tabbed folders shown on the LCD
display, press the RIGHT and LEFT keys�� The navigation
rolls over from the last to the first folder and vice-versa��
Table 4 : Folder Bar Icons
Folder Icon Description
Name
Home System performance and status
main information�� The first page
of this folder is the default page
when the controller first powers
up��
Operator System options and
Settings configuration settings��
Events System events log��
Trip History Details on the most recent trips��
Maintenance Status and notification setup for
compressor maintenance items��
General General settings such as
Settings Language, Time, and Units of
Measure��
Integral Integral Sequencing
Sequencing communication status and
configuration��
Status Measurements or status from/of
all analog and digital I/O��
Factory Compressor tuning parameters��
Settings Also displays hardware and
software versions��
PAGE NAVIGATION

Once the desired folder is selected, press the DOWN key
to move to the page selection area and then use the
RIGHT and LEFT keys to select the desired page�� Use the
UP key to get back to the folder tabs��
Table 5 : Title Bar Page Icons
Icon
Start of the page selection area��
Indicates that there are more pages available
by navigating right��
Indicates that there are more pages available
by navigating left��
80448418 Rev.C
RELEASED 20/Jul/2016 17:56:55 GMT
Description
ACCESSING PARAMETERS

After the desired page is selected, the page's parameters
can be selected by using the DOWN key�� The cursor will
move to the next parameter each time the DOWN key is
pressed�� Use the UP key to go back to the previous one��
The cursor rolls over, so once the last parameter is
selected, pressing the DOWN key will navigate the
cursor to the Folder Bar�� If the first parameter is selected,
pressing the UP key will move the cursor to the page
selection area��
Once selected, access parameters by pressing the ENTER
key�� Make changes using the NAVIGATION keys and then
enter the setting by pressing the ENTER key again�� After a
parameter is accessed, pressing the ENTER key will enter
the current setting into the control program and navigate
the cursor back to the selected parameter on the page��
When the cursor is on a parameter that has an enabled/ disabled box, pressing the ENTER key will cause the
setting to toggle��
This icon appears on numeric entry windows (see
Figure 69)�� Placing the cursor on it and then pressing the
ENTER key will cancel the entry and any changes that
were made��
Figure 4 : Numeric Entry Window
Not all pages have adjustable parameters�� Some just
have read-only information��
DASHBOARD ICONS

The dashboard is intended to be a quick at-a-glance
view of system status�� The following table lists standard
dashboard icons and their definition�� Note that the color
of these icons changes based on the state set by the
application while running��
NOTICE