Safety - Schulz SRP 3040E Manual De Instrucciones

SCREW AIR COMPRESSOR

SAFETY

WARNING
Improper installation or improper use of this equipment can result in personal injury and material
damage.
In order to avoid injury or damage, please adhere to the following recommendations:
1. This equipment presents the following hazards:
- extremely hot parts, energized electrical components, compressed air parts and moving parts;
- turns on or off automatically relative to system pressure or actuation of the thermal protection
elements;
- may cause mechanical or electrical interference in nearby equipment;
- installation must be protected from access by unauthorized persons, children or animals;
- operate and maintain this equipment with appropriate supervision and appropriate use of personal
protective equipment;
- unit must be installed and operated in well ventilated areas with protection from elements;
2. Never attempt to exceed the maximum operating pressure indicated on the compressor.
3. Do not attempt maintenance before disconnecting the electrical power supply.
4. Do not adjust the safety valve or pressure switch. They are permanently adjusted at the factory.
5. Do not attempt to repair or air/oil tank. Certification and operation tank may be adversely affected.
Consult your
6. Never run the air/oil tank above the maximum pressure indicated in its identification tag.
7. In case of an inspection, the user of this product must keep the pressure vase book provided by the
manufacturer available, attached to the other safety documents required by NR-13 of Labor Ministry of
Brazil, for as long as the vase is used, until it is disposed of. The final user must follow the resolutions
set forth in NR-13 as to the installation, maintenance, and operation of the pressure vase (compressed
air receiver). The useful life of a pressure vase depends on several factors that do contribute to
determine it. This aspect must be monitored and established by a certified professional, according to
NR-13. Remark: The hydrostatic test carried out during the product manufacturing does not replace
the initial inspection, which must be carried out at the location where the product is installed, duly
followed up by a certified professional, according to NR-13 MTb. Schulz S.A., manufacturer of the
product, declares that the local legislation and inspection rule upon the above provided information,
and that all prudent, preventive, and wise safety procedures must prevail.
8. Air compressing is a heat generating process. Surfaces and parts are subject to high temperatures,
therefore, to avoid burns, be careful when handling them.
9. Do not use the compressed air from this equipment for breathing air. It may contain carbon monoxide
or other harmful substances. If used for such purpose, special filters after the compressor must be
installed. Consult your
10. Before connecting the compressor re-fastening of the electrical conection.
11. Keep the refrigeration air inlet always
38).
12. Never use solvent to clean the compressor's internal/external parts. Use neutral detergent.
13. Never activate the safety valve if the compressor is operating/pressurized, to avoid burns.
14. Avoid the accumulation of solvents, paints or other chemicals that can cause explosion risks, or compressor
damage.
15. Do not carry out maintenance jobs with the compressor on. For safety reasons, press the emergency
button and (Figures 11 and 12, page 46 and 47) located in the instrument panel. 5
16. If the equipment shows any irregularities, stop its operation immediately and get in touch with the nearest
SCHULZ Authorized - Technical Distributor
36
Keep these Instructions
SCHULZ Authorized - Technical Distributor
SCHULZ Authorized - Technical Distributor
17
7
.
clean, to prevent the propeller from sucking remains (Figure 3, page
.
SRP 3040E - SRP 3040
for further information.