Electrical Connections - baltur TBL 45P Manual De Instrucciones

ELECTRICAL CONNECTIONS

VersiOn WiTH HYDraULiC JaCK
The three-phase power supply line must have a switch with fuses.
The standards also require a switch on the burner's power line
located outside the boiler room where it can be accessed easily.
Refer to the wiring diagram for electrical connections (line and
thermostats). To connect the burner to the supply line, proceed as
follows:
• In the case of models with mono-phase power supply insert the
two 7 and 4 pole plugs in the sockets located below the electrical
panel base (fig. 1).
• In the case of models with three-phase power supply, unscrew
the 2 screws (1) and pull back lightly the cover to detach it from
the electrical panel base (fig. 2). Lift up the cover to reach the
electrical components.
• Connect the power supply cables (2) to the remote control,
fasten the grounding cable (3) and tighten the relative cable
gland (Fig.3). Connect the two 7 and 4 pole plugs.
• Re-close the lid taking care to position the two hooks (4) correctly
in their respective housing (fig. 4).
only professionally qualified personnel may open the burner
electrical panel.
Figure 1
10 / 28
0006081349_201307
Figure 2
Figure 3
Figure 4